Seagull cassutt 3M Racer Dokumentacja Pobierz pdf (Strona 17)

17

www.seagullmodels.com

BALANCING.

 1) It is critical that your airplane be

balanced correctly. Improper balance will

cause your plane to lose control and crash.

THE CENTER OF GRAVITY IS LOCATED

65MM BACK FROM THE LEADING EDGE

OF THE WING AT THE WING ROOT.

 3) Turn the airplane upside down. Place

your fingers on the masking tape and carefully

lift the plane .

 2) Mount the wing to the fuselage. Using a

couple of pieces of masking tape, place them

on the top side of the wing

65mm back from

the leading edge of the wing at the wing root.

APPLY THE DECALS.

1) If all the decals are precut and ready to

stick. Please be certain the model is clean and

free from oily fingerprints and dust. Position

decal on the model where desired, using the

photos on the box and aid in their location.

2) If all the decals are not precut, please use

scissors or a sharp hobby knife to cut the

decals from the sheet. Please be certain the

model is clean and free from oily fingerprints

and dust. Position decal on the model where

desired, using the photos on the box and aid

in their location.

ATTACHMENT WING-FUSELAGE.

Wing tube.

Attach the aluminium tube into fuselage.

Insert two wing panels as pictures below.

Wing bolt.

INSTALLING THE RECEIVER.

 1) Plug the five servo leads and the switch

lead into the receiver. Plug the battery pack

lead into the switch also.

 2) Wrap the receiver pack in the protec-

tive foam rubber to protect them from vibra-

tion.



3) Route the antenna in the antenna tube

inside the fuselage and secure it to the bot-

tom of fuselage using a plastic tape.

Receiver.

BALANCING.

1 2 ... 12 13 14 15 16 17 18 19

Komentarze do niniejszej Instrukcji

Brak uwag